Filter
Top Products
221
IEEE 488.2 Common Commands
*PCB (Pass Control
Back)
The Test Set accepts the *PCB command. Refer to “Passing Instrument Control”
in the Advanced Operations chapter of the Agilent 8920B Programmer’s Guide.
*SRE (Service
Request Enable)
The Test Set responds to the *SRE command. See “Status Byte Register” and
“Service Request Enable Register” in the Advanced Operations chapter of the
Agilent 8920B Programmer’s Guide for a detailed explanation of the *SRE
command.
*SRE? (Service
Request Enable
Query)
The Test Set responds to the *SRE? command. See “Status Byte Register” and
“Service Request Enable Register” in the Advanced Operations chapter of the
Agilent 8920B Programmer’s Guide for a detailed explanation of the *SRE?
command.
*STB? (Status Byte
Query)
The Test Set responds to the *STB? command. See “Status Byte Register” and
“Service Request Enable Register” in the Advanced Operations chapter of the
Agilent 8920B Programmer’s Guide for a detailed explanation of the *STB?
command.
*TRG (Trigger) The *TRG command is equivalent to the IEEE 488.1 defined Group Execute
Trigger (GET) message and has the same effect as a GET when received by the
Test Set. The Test Set responds to the *TRG command by triggering all currently
active measurements.