Filter
Top Products
418
S:\agilent\8920\8920b\PRGGUIDE\BOOK\CHAPTERS\ibasic.fb
Chapter 7, IBASIC Controller
PROGram Subsystem
Saving an IBASIC Program To A Memory Card
The following procedure can be used to save an IBASIC program from the IBASIC
Controller’s RAM memory to a memory card inserted into the front panel of the Test
Set.
1. Press LOCAL, SHIFT, CANCEL on the Test Set to perform an IBASIC reset.
2. If the memory card has not been initialized, insert it into the Test Set and execute the
following command on the external controller:
OUTPUT 714;"PROG:EXEC ’INITIALIZE"":INTERNAL,4""’"
3. Insert the initialized memory card into the Test Set.
4. Define the memory card as the Mass Storage device by executing the following command
on the external controller:
OUTPUT 714;"PROG:EXEC ’MSI "":INTERNAL,4""’"
5. Save the program to the memory card by executing the following command on the external
controller:
OUTPUT 714;"PROG:EXEC ’SAVE ""<filename>""’"