Filter
Top Products
199
Equivalent Front-Panel Key Commands
To Set Measurement Reference Point Display Units. Use the :REFerence:DUNits
commands to set a measurement reference point’s Display Units. Refer to
“Display Units (DUNits)” on page 75 for description of Display Units.
Syntax
:REFerence:DUNits <disp_units>
Example
OUTPUT 714;"MEAS:RFR:POW:REF:DUN DBM"
This sets the measurement reference point’s Display Units for the TX
Power measurement to dBm.
NOTE: When querying a measurement reference point through GPIB, the Test Set always
returns numeric values in Attribute Units, regardless of the current Display Units
or GPIB Units settings. Numeric values are expressed in scientific notation.
To Query Measurement Reference Point Display Units.
Use the
:REFerence:DUNits? commands to query a measurement reference point’s
Display Units. Refer to
“Display Units (DUNits)” on page 75 for description of
Display Units.
Syntax
:REFerence:DUNits?
Example
OUTPUT 714;"MEAS:RFR:POW:REF:DUN?"
ENTER 714;Disp_unit$
This queries the measurement reference point’s Display Units for the
TX Power measurement.
NOTE: When querying a measurement reference point through GPIB, the Test Set always
returns numeric values in Attribute Units, regardless of the current Display Units
or GPIB Units settings. Numeric values are expressed in scientific notation.