Filter
Top Products
Greensmaster 3320/3420 GroomerPage 9 -- 19
2. Install LH support plate to left side of cutting unit:
A. Apply antiseize lubricant to threads of LH groom-
er arm lift rod.
B. Position support plate to cutting unit making sure
that LH groomer arm lift rod is positioned through
bushing in support plate.
C. Place spring washer and lock nut on lift rod
threads (Fig. 20). Tighten lock nut.
D. Position motor mount to groomer support plate
(Fig. 19). Secure motor mount and support plate to
cutting unit with two (2) socket head screws and lock
nuts.
3. Install grooming reel, front roller and RH drive plate
to cutting unit (see Grooming Reel (Forward Rotating or
Counter Rotating) in this section).
4. Check and adjust grooming reel height and mower
height--of--cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
7. Connect the cutting unit power disconnect couplers.
NOTE: After greasing groomer bearings, operate
groomerf or 30 seconds, stop machineand wipeany ex-
cess grease from groomer shaft and seals.
1. RH drive plate assy
2. Bearing (2 used)
3. Seal (2 used)
Figure 22
3
1
2
2
3
Seal lips
(toward center of
cutting unit)
COUNTER ROTATING GROOMER
1. LH support plate
2. Bearing
3. Seal
4. Plug
Figure 23
Seal lip
(toward center of
cutting unit)
3
2
4
1
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
5. Seal lip
6. Support plate bearing
7. Drive plate (RH side)
8. Support plate (LH side)
Figure 24
1
2
3
4
5
5
5
6
7
8
Groomer