Filter
Top Products
Greensmaster 3320/3420Page 6 -- 14Electrical System
Main Menu Screen
The main menu screen can be accessed from the Info-
Center main information or splash screen by pressing
and releasing the menu/back button (left button) on the
display. Onceto themain menuscreen (Fig.18), naviga-
tionto thefive(5) differentmenu itemscan occur. Press-
ing the move to menu item button (center button) allows
a d ifferent menu item to be highlighted. Selection of the
highlighted item is completed by pressing the choose
item button (right button).
The main menu items include faults, service, diagnos-
tics, settings and about. These menu items are de-
scribed below.
To return to the main information screen from the main
menu screen, press the back button (left button).
1. Main menu
2. Menu items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 18
1
3
4
5
3
4
Main Menu
Faults
Service
Diagnostics
2
5
Faults Screen
The faults screen (Fig. 19) will list all machine electrical
faults that have occurred since the faults were last
cleared from the InfoCenter. The faults will be identified
by a fault number and when the fault occurred. Faults
that might occur on the machine are listed in Fault
Codes in the Troubleshooting section of this chapter.
The InfoCenter fault log can be cleared by selecting the
clear system faults menu item. The cleared faults will be
removed from the InfoCenter but will be retained in the
TEC controller memory.
If a f ault occurs during machine use, there may be a
change in machine functionality due to the fault. Should
there be machine operation issues due to a fault, a first
step to remedy the issue would be to disengage the cut-
ting units, release the traction pedal, turn the key switch
OFF and allow all machine functions to stop. Then, at-
tempt to restart the machine to see if operation has re-
turned to normal. Some faults will be reset during the
restart and will then allow normal function. If a fault con-
tinues to occur, further system evaluation and possible
component repair or replacement will be necessary.
To return to the main menu screen from the faults
screen, press the back button (left button).
1. Fault menu
2. Fault items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 19
1
3
5
3
4
Faults
#32
Clear System Faults
-- 57.3 Ago
2
5