Filter
Top Products
Greensmaster 3320/3420Page 6 -- 98Electrical System
Cutting Reel Motor Service
1. Torx head screw (12 used)
2. Motor cover
3. O--ring
4. Wave washer (2 used)
5. Bearing (2 used)
6. Rotor
7. Bearing (2 used)
8. O--ring (2 used)
9. Housing/controller/cable assembly
10. O--ring
11. Output gear
12. Gearbox cover
13. Shaft seal
14. O--ring
Figure 114
5
7
7
5
6
11
8
1
4
3
10
8
9
12
14
13
2
4
1
35 to 45 in--lb
(4 to 5 N--m)
35 to 45 in--lb
(4 to 5 N--m)
NOTE: Ifmotorhousing, controllerorcable damageoc-
curs, cutting reel motor replacement is necessary.
These components are not available separately.
Disassembly (Fig. 114)
1. Remove six (6) torx head sc rews that secure gear-
box cover (item 12) to front of motor housing.
2. Carefully slide gearbox cover from front of motor.
3. Remove and discard O--rings (items 8 and 10) from
gearbox cover.
4. Slide output gear assembly (items 5, 11 and 7) from
motor housing. Remove wave washer (item 4).
5. Remove six (6) torx head screws that secure motor
cover (item 2) to rear of motor housing. Leave cover on
rotor shaft.
IMPORTANT: The rotor magnets are very powerful
and can cause therotor to shiftposition veryrapidly
duringremoval.Be cautious during rotor removalto
prevent component damage or personal injury.
6. Use cutting reel motor rotor tool set (see Special
Tools in thischapter) to carefully remove rotorassembly
(items 5, 6 and 7) and motor cover (item 2) from motor
housing.