Filter
Top Products
Greensmaster 3320Page 3 -- 14Gasoline Engine
Engine
Figure 9
1. Engine assembly
2. Spacer screw
3. Muffler
4. Muffler mount
5. Cap screw (4 used)
6. Flange nut (4 used)
7. Muffler shield
8. Hardened washer (8 used)
9. Cap screw (4 used)
10. Muffler clamp
11. Lock nut (4 used)
12. Pump mount
13. Cap screw (4 used)
14. Exhaust manifold
15. Gasket (2 used)
16. Flange head screw (4 used)
17. Engine frame
18. Flange head screw (3 used)
19. Square key
20. Lock washer
21. Square head screw (2 used)
22. Flat washer (4 used)
23. Generator pulley
24. Coupling
25. Socket head screw (4 used)
FRONT
RIGHT
1
2
3
4
5
6
7
9
10
11
12
17
13
18
19
14
21
15
16
8
8
20
22
90 to 11 0 in--lb
(10.2 to 12.4 N--m)
Antiseize
Lubricant
25 to 38 ft--lb
(34to51N--m)
20 to 25 in--lb
(2.3 to 2.8 N--m)
170 to 200 in--lb
(19.3 to 22.6 N--m)
23
24
25
Engine Removal (Fig. 9)
1. Parkmachineon alevelsurface, disengage and low-
er cutting units, move functional control lever to neutral
(N), engage parking brake, stop the engine and remove
the key from the ignition switch. Wait for all machine
movement to stop.
CAUTION
The engine and exhaust system may be hot.
Avoid possible b urns, allow engine and exhaust
system to cool before working on the engine.
DANGER
Gasoline isflammable. Usecautionwhen storing
or handling it. Do not smoke while filling the fuel
tank. Do not fill fuel tank while engine is running
or in an enclosed area. Always fill fuel tank out-
side and wipe up any spilled fuel before starting
the engine. Store fuel in a clean, safety--ap-
proved container and keep the cap in place. Use
gasoline for the engine only; not for any other
purpose.