Filter
Top Products
Greensmaster 3320/3420Page 6 -- 92Electrical System
Generator Assembly Service
1. Generator assembly
2. Plug (2 used)
3. Flocked seal
4. Wave washer
5. Retaining ring
6. Cap screw (2 used)
7. Flat washer (2 used)
8. Washer head screw (6 used)
9. Controller assembly
10. Flange nut (2 used)
11. Cover gasket
12. Access cover
13. Washer head screw (2 used)
14. Flange head screw (3 used)
15. Collar
16. Flange head screw
17. Generator cover
18. Torx screw (4 used)
19. Flat washer (4 used)
20. Fan screen
21. Generator fan
22. Woodruff key
23. Button head screw (2 used)
24. O--ring
Figure 107
170 to 190 in--lb
(19.3 to 21.3 N--m)
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
2
21
22
15 to 25 in--lb
(1.8 to 2.8 N--m)
70 to 80 in--lb
(8.0 to 9.0 N--m)
23
75 in --lb
(8.5 N--m)
8
70 to 80 in--lb
(8.0 to 9.0 N--m)
20 to 26 ft--lb
(28to35N--m)
20 to 26 ft--lb
(28 to 35 N--m)
24
Disassembly (Fig. 107)
1. Remove fan screen (item 20) from generator fan.
2. Remove generator cover (item 17) from generator
assembly.
3. Remove access cover (item 12) and cover gasket
(item 11) from controller. Discard cover gasket.
4. Carefully remove generator and controller harness
connectors from controller opening. Note position of
connectors and wire harnesses for assembly purposes.
Unplug connectors.
5. Remove three (3) flange head screws (item 14) that
secure generator stator conductors to controller con-
nectors.