Filter
Top Products
Greensmaster 3320/3420
DPA Cutting Units
Page 8 -- 27
Reel Motor Adapter
Removal
1. Position machine on a clean and levelsurface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the electric reel motor from the cutting unit
(see Cutting Reel Motors in the Service and Repairs
section of Chapter 6 -- Electrical System). Move motor
tostorage locationonf ront ofcutting unitsuspensionas-
sembly.
3. Remove reel motor adapter from cutting unit side
plate using Fig. 27 as a guide.
4. Remove O--rings as necessary fr om motor adapter
(Fig. 28).
Installation
1. If large O--ring was removed from flange of motor
adapter, lubricate O--ring with grease. Small O--rings
should be installed into motor adapter without lubrica-
tion. Make sure that O--rings are correctly positioned in
grooves in adapter.
2. Install reelmotor adapterto cuttingunit side plateus-
ing Fig. 27 as a guide.
3. Secureelectricreelmotor tothe cuttingunit(seeCut-
ting Reel Motors in the Service and Repairs section of
Chapter 6 -- Electrical System).
1. Hex nut
2. Reel motor adapter
3. Socket head screw
4. Motor clamp
Figure 27
2
4
3
1
1. Adapter
2. O--ring
3. O--ring
Figure 28
2
3
1
DPA Cutting
Units