Filter
Top Products
Groundsmaster 4000--D Hydraulic System (Rev. B)Page 4 -- 17
Steering Circuit
A three section gear pump is coupled to the piston (trac-
tion) pump. Thegear pump section farthest from the pis-
ton pump supplies h ydraulic flow to the steering control
valve and the lift/lower control valve. Pump hydraulic
flow is delivered to the two circuits through a proportion-
al flow divider. The gear pump takes its suction from the
hydraulic reservoir. Steering circuit pressure is limited
by a relief valve located in the steering control.
With the steering wheel in the neutral position (rear
wheels positioned straight ahead) and the engine run-
ning, flow enters the steering control valve at the P port
and goes through the steering control spool valve, by--
passing the rotary meter (V1) and steering cylinder.
Flow leaves the control valve through the PB port to the
oil filter and traction charge circuit.
Left Turn
When a left turn is made with the engine running, the
turning of thesteering w heel positions thespool valve so
that flow goes through the top of the spool. Flow entering
the steering control v alve at the P port goes through the
spool and is routed to two places. First, most of the flow
through the valve is by--passed out the PB port back to
the oil filter and traction charge circuit. Second, the re-
mainder of the flow is drawn through the rotary meter
(V1) and out the L port. Pressure contracts the piston for
a left turn. The rotary meter ensures that the oil flow to
the cylinder is proportional to the amount of the turning
on the steering wheel. Fluid leaving the cylinder flows
back through the spool valvethen through theT port and
to the hydraulic reservoir.
The steering wheel and steering control valve return to
the neutral position when turning is completed.
Right Turn
When a right turn is made with the engine running, the
turning of thesteering w heel positions thespool valve so
that flow goes through the bottom of the spool. Flow en-
tering the steering control v alve at the P port goes
through the spool and is routed to two places. As in a left
turn, most of the flow through the valve is by--passed out
the PB port back to the oil filter and traction charge cir-
cuit. Also like a left turn, the remainder of the flow is
drawn through rotary meter (V1) but goes out port R.
Pressure extends the piston for a right turn. The rotary
meter ensures that the oil flow to the cylinder is propor-
tional to the amount of the turning on the steering wheel.
Fluid leaving the cylinder flows back through the spool
valve then through the T port and to the hydraulic reser-
voir.
The steering wheel and steering control valve return to
the neutral position when turning is completed.
Figure 8
1350
PSI
PB
STEERING
T
R
P
L
PISTONMOVEMENT
CONTROL
1350
PSI
PB
STEERINGCYLINDER
STEERING
T
R
P
L
PISTONMOVEMENT
CONTROL
1350
PSI
PB
STEERINGCYLINDER
STEERING
T
R
P
L
CONTROL
LEFT TURN
NEUTRAL POSITION
RIGHT TURN
NOPISTONMOVEMENT
STEERINGCYLINDER
Hydraulic
System