Filter
Top Products
Groundsmaster 4000−DPage 6 − 14Axles, Planetaries, and Brakes (Rev. B)
9. Install steering cylinder to axle assembly (see Steer-
ing Cylinder in Service and Repairs section of Chapter
4 − Hydraulic System).
10.Install hydraulic motor to axle assembly (see Rear
Axle Motor in Service and Repairs section of Chapter 4
− Hydraulic System).
WARNING
Failure to maintain proper wheel lug nut
torque could result in failure or loss of wheel
and may result in personal injury.
11.Install wheels to axle. Torque wheel lug nuts from 85
to 100 ft−lb (115 to 135 N−m).
12.Lower machine to ground.
13.Fill axle with SAE 85W−140 weight gear lube (see
Operator’s Manual). Lubricant capacity is approximate-
ly 80 fl oz (2.37 l) for the axle and 16 fl oz (.47 l) for the
gearbox.
14.Check rear wheel toe−in and adjust if necessary (see
Operator’s Manual).
15.Check steering stop bolt adjustment. When the
steering cylinder is fully extended (right turn), a gap of
1/16” (1.6 mm) should exist between bevel gear case
casting and stop bolt on left axle case. Figure 12 shows
stop bolt location.
1. Steering stop bolt 2. Bevel gear case (LH)
Figure 12
2
1