Filter
Top Products
Rev. E
Groundsmaster 4000−D Page 5 − 3 Electrical System
Special Tools
Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The meter can test electrical components and circuits
for current, resistance, or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt−
Ohm−Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Figure 1
Skin−Over Grease
Special non−conductive grease (Toro Part No.
505−165) which forms a light protective skin which helps
waterproof electrical switches and contacts.
Figure 2
Deck Proximity Switch Adjustment Tool
The Deck Proximity Switch Adjustment Tool (TOR4095)
is designed to assist in the adjustment of the cutting
deck position switches for cutting blade shutdown dur-
ing deck lift.
Figure 3
Electrical
System