Filter
Top Products
U23841-J-Z915-6-76 233
Interoperability Administering gateways
7.4.5 Obtaining information on a gateway
As an administrator, you can display the status and the definition of local or
partner gateways.
Displaying the definition of gateways
● Information on the definition of gateways can be obtained with the following
command:
xpshow -gtw [selection] [-di display]
If selection is not specified, the command refers to all the gateways in the
local Xprint V7.0 system. Otherwise you can either specify a list of the
gateways on which you want information to be displayed, or you can use the
-scl “selection_criteria_list” option (see section “Selection criteria list” on
page 266 in the Appendix) to define a list of criteria according to which the
gateways are selected.
With the option -di display you can determine the scope of the display as for
all the other Xprint V7.0 objects.
Displaying the status of local gateways
● You can display the status (active or not active) of a local gateway with the
following command:
xpstat -gtw [selection] [-di display]
For selection you have the same options as described under the xpshow
command (see above).
Displaying the status of partner gateways
● You can display the status of a partner gateway if the corresponding local
gateway is in the ACTIVE state with gateway_out enabled. For partner
gateways, all the fields are left empty except the State field. Use the
following command:
xpstat -gtw [selection] [-di display]
For selection you have the same options as described under the xpshow
command (see above). When the identifier list is empty or contains only *
then only LOCAL gateways will be looked for. In other cases, both LOCAL and
PARTNER gateways will be looked for.