U23841-J-Z915-6-76 189
Configuring Xprint V7.0 Administering recovery rules
The asterisk (*) stands for any error other than those specified earlier in the
recovery rules file. The asterisk must be specified as the last rule.
A printer which does not allow polling or handshaking is connected directly
to a LAN. In the event of a PowerOFF error message on the printer, Xprint V7.0
by default restarts the job with the last sent page.
However, as the last page sent is not necessarily the last printed page, the
rule above is more useful: In the case of a PowerOFF error message, the
document is spooled in again; if the connection cannot be re-established
within 15 minutes, the printer is set to the status NOT_ACTIVE so that no more
print jobs can be sent to it. Now the printer can be switched back on and/or
the problem can be eliminated.
● When you have fully defined your recovery rules, save your file.
● Add the new recovery rule to the Xprint V7.0 system:
xpadd -rec rule_name -fi rule_file [-ca comment]
where rule_name is a name you want to assign to a set of new recovery rules
in the Xprint V7.0 system and rule_file specifies the file name of the source
file you have created. If this file is not located in the Xprint V7.0 directory
opt/Xprint/RR, you must specify the absolute path name. With comment
you can specify a comment, for example on the purpose of this rule, which
can be useful for later administration of recovery rules.
Example
– To add the recovery rule RR1 from the recovery rules file
opt/Xprint/RR/my_RR_1:
xpadd -rec RR1 -fi my_RR_1
#Key : Time : Exception : Action :
PowerOFF : 900 : stopped : Respool :
stopped : : : Stop :