Filter
Top Products
U23841-J-Z915-6-76 111
Configuring Xprint V7.0 Predefined printers
When you have performed these steps, Xprint V7.0 suggests a default configu-
ration and at the same time offers you the option of modifying this configuration:
● A display similar to the following appears on the screen:
Proposal of device definition (type "HP Laserjet 4P", emulation
"HP-LASERJET"):
-- 1 NAME: HPLJ-4P
-- 2 Host: colorado
-- 3 pcl: HP-LASERJET
-- 4 Address: /dev/lp0
-- 5 Connection type: SERIAL
-- 6 Protocol: XON
-- 7 Speed: 9600
-- 8 Parity: NONE
-- 9 Significant bits: 8
-- 10 Enable polling: RESET
Please type a number to update an attribute, press return to start
modification processing, ’q’ to quit or ’?’ for help :
5
To modify the displayed configuration, you must select the corresponding
number and confirm with
"Enter". Then the corresponding entry is marked,
e.g.
>> 5 Connection type: SERIAL
● Confirm again with "Enter".
Then the possible parameters for the relevant option are displayed, from
which you can select one by marking the number and confirming with
"Enter" , e.g.:
Updating attribute:
"Connection type" .
Current value: "SERIAL"
Possible values are:
1. SERIAL 2. PARALLEL 3. LAN
4. SCSI
Type entry number (any other entry means no change) : 2
● Once you have made all the settings according to your requirements,
confirm with
"Enter". Xprint V7.0 then confirms the entry of the new printer
with the following message:
Updating device model :
"HPLJ-4P" .