Filter
Top Products
U23841-J-Z915-6-76 191
Configuring Xprint V7.0 Administering recovery rules
● You can cancel the assignment of the recovery rule with the following
command:
xpmod -dev [selection] -rr-
This command revokes the current assignment of a recovery rule to the
specified printer(s).
● Now you can reactivate the printer:
xpchange -dev [selection]
6.14.4 Modifying recovery rules
If you want to modify recovery rules, you must modify their source file (usually
located in the Xprint V7.0 directory .../RR) and then recompile it. Proceed as
follows:
● Modify the source file of the relevant recovery rule using an ASCII editor. To
do this, use the procedure described in the section “Defining a recovery rule”
on page 186.
● Recompile the recovery rules using the following command:
xpmod -rec rule_name -fi rule_file [-ca comment]
where rule_name is the name of the modified recovery rules in the Xprint
V7.0 system and rule_file specifies the file name of the modified source file.
If this file is not located in the Xprint V7.0 directory .../RR, you must specify
the absolute path name. With comment you can specify or modify a comment.
If the xpmod command is called on a host other than the one on which
the rule file was added with xpadd, Xprint V7.0 uses the original host and
path to access the file. You can make Xprint V7.0 modify the local copy
of the selected file by using the -ho- option.
i