Filter
Top Products
Groundsmaster 4100--D
Page 1 -- 4
Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments t hat
may interfere with the safe and proper raising of
themachine.Always chock orblockwheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Jacking the Front End (Fig. 1)
1. Set parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack securely under the frame, just to the in-
side of the front tire. Jack front wheel off the ground.
3. Once the machine is raised, position suitable jack
stand under the frame as close to the wheel as possible
to support the machine.
Jacking the Rear End (Fig. 2)
1. Place jack securely under the center of rear axle.
2. Chock both front tires. Jack rear of machine off the
ground.
3. Once the machine is raised, use suitable jackstands
under the rear axle to support the machine.
1. Frame jacking point 2. Front tire
Figure 1
1
2
2
1
1. Rear axle jacking point 2. Rear tire
Figure 2
1
2
2