Filter
Top Products
Groundsmaster 4100--DPage 6 -- 16Axles, Planetaries and Brakes
8. Install steering cylinder to axle assembly (see Steer-
ing Cylinder Installation in the Service and Repairs sec-
tion of Chapter 4 -- Hydraulic System).
9. Install hydraulic motor to axle assembly (see Rear
Axle Motor Installation in the Service and Repairs sec-
tion of Chapter 4 -- Hydraulic System).
10.Install wheels to axle.
WARNING
Failure to maintain proper wheel lug nut torque
could result infailureorlossofwheeland may re-
sult in personal injury.
11.Lower machine to ground. Torque wheel lug nuts
from 85 to 100 ft --lb (115 to 135 N--m).
12.Fill axle and input gearbox with SAE 85W--140
weightgear lube.Lubricantcapacity isapproximately 80
fl. oz. (2.37 liters) for the axle and 16 fl. oz. (0.47 liters)
for the gearbox.
13.Check rear wheel toe--in and adjust if necessary.
14.Check steering stop bolt adjustment. When the
steering cylinder is fully extended (right turn), a gap of
1/16” (1.6 mm) should exist between bevel gear case
casting and stop bolt on left axle case. Figure 14 shows
stop bolt location.
1. Steering stop bolt 2. Bevel gear case (LH)
Figure 14
1
2