Filter
Top Products
Groundsmaster 4100--DHydraulic System Page 4 -- 30
Problem Possible Causes
Cutting deck (or wing decks) will not
raise.
Engine RPM is too low.
Hydraulic oil level in reservoir is low.
Lift arm pivots are binding.
Relief valve in lift/lower control valve is stuck.
Pilot valve in lift/lower control valve is damaged or sticking.
Lift cylinder(s) is (are) damaged.
Gear pump section for lift/lower control valve is inefficient.
Cutting deck (or wing decks) raise,
but will not stay up.
NOTE: Lift cylinders cannot provide
an absolutely perfect seal. The cut-
ting deck will eventually lower if left
in the raised position during storage.
Lift circuit lines or fittings are leaking.
Lift cylinder is damaged.
Detents in lift/lower control valve are worn.
Front cutting deck drops too fast or
too slow.
Flow control valve is not adjusted properly.
Cutting deck (or wing decks) will not
lower.
Lift arm pivots are binding.
Counterbalance pressure is excessive.
Pilot valve in lift/lower control valve is damaged or sticking.
Lift cylinder is damaged.
Lift/lower control valve is worn or damaged.