Filter
Top Products
Groundsmaster 4100--D Cutting DeckPage 8 -- 17
Installation (Fig. 13)
1. Position spindle on cutting deck noting orientation of
grease fitting(Fig. 15). Securespindleassemblytodeck
with removed fasteners.
2. Install cutting blade, anti--scalp cup and blade bolt.
Tighten blade bolt from 88 to 108 ft--lb (119 to 146
N--m).
3. Slowly rotate cutting blades to verify that blades do
not contact any deck component(s).
4. Install drive belt and adjust belt tension ( see IdlerAs-
sembly Installation in this section).
5. If drive spindle was removed, install hydraulic motor
to cutting deck (see Cutting Deck Motor Installation in
the Service and Repairs Section of Chapter 4 -- Hydrau-
lic System).
6. Install belt covers to cutting deck.
1. Flange head screw 2. Hydraulic motor
Figure 14
1
2
1
1. Driven spindle
2. Driven spindle (high pulley)
3. Drive spindle (wing deck)
4. Drive spindle (center deck)
5. Spindle grease fitting location
Figure 15
5
3
2
5
1
1
4
3
5
1
5
5
5
Cutting Deck