Filter
Top Products
Greensmaster 3150 Page 1 -- 5 Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments t hat
may interfere with the safe and proper raising of
the machine.Alwayschock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by j ack
stands, the machine may move or fall, which
may result in personal injury.
Front End Jacking
1. Apply parking brake and chock rear tire to prevent
the machine from moving. Make sure that cutting units
are fully lowered.
2. Position jack securely under the frame jacking point:
A. The left side jacking point is the frame channel
under the step behind the LH front wheel.
B. The right side jacking point is the ROPS support
bracket behind the RH front wheel (Fig. 1).
3. Jack front of machine off the ground.
4. Position appropriate jack s tands under the frame as
close to the wheel as p ossible to support the machine.
Rear End Jacking
1. Apply parking brake and chockboth front tires to pre-
vent the machine from moving. Make sure that cutting
units are fully lowered.
2. Place jack securely below the rear castor fork.
3. Jack rear of machine off the ground.
4. Position appropriate jack stands under the frame to
support the machine.
1. ROPS support bracket
Figure 1
1
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the traction unit and the cutting units of the Greensmas-
ter 3150. If any decal becomes illegible or damaged, in-
stall a new decal. Part numbers are listed in your Parts
Catalog and Operator’s Manual. Order replacement de-
cals from your Authorized Toro Distributor.
Safety