Filter
Top Products
Greensmaster 3150Page 1 -- 4Safety
Maintenance and Service
1. Before servicing or making adjustments to the ma-
chine, stop the engine, remove key from switch to pre-
vent accidental starting of the engine.
2. Be sure entire machine is in good operat ing condi-
tion. Keep all nuts, bolts, screws and hydraulic fittings
tight.
3. Make sure all hydraulic line connectors are tight,and
all hydraulic hoses and lines are in good condition be-
fore applying pressure to the system.
4. Keep body and hands away from pin hole leaks or
nozzles that eject hydraulic fluid under high pressure.
Use paper or cardboard, not hands, to search for leaks.
Hydraulic fluid escaping under pressure can have suffi-
cient force to penetrate skin and do serious damage. If
fluid is ejected into the skin it mustbe surgically removed
within a few hours by a doctor familiar with this form of
injury or gangrene may result.
5. Before disconnecting or performing any work on the
hydraulic system, all pressure in system must be re-
lieved by stopping engine and lowering cutting units and
attachments to the ground.
6. To reduce potential fire hazard, keep the engine area
free of excessive grease, grass, leaves and accumula-
tion of dirt. Never wash a warm engine or electrical con-
nections with water.
7. Check all fuel lines for tightness and wear on a regu-
lar basis. Tighten or repair fuel lines as needed.
8. If the engine must be running to perform a mainte-
nance adjustment, keep hands, feet, clothing and any
other parts of the body away from the cutting units, at-
tachments and any moving parts. Keep everyone away.
9. Do not overspeed the engine by changing governor
settings. To assure safety and accuracy, have an Autho-
rized Toro Distributor check maximum engine speed
with a tachometer. Maximum governed engine speed
should be 2850 +
50 RPM.
10.Engine must be shut off before checking oil or adding
oil to the crankcase.
11.If major repairs are ever needed or if assistance is
desired, contact your Authorized Toro Distributor.
12.At the time of manufacture, the machine conformed
to the safety standards for riding mowers. To assure op-
timum performance and continued safety certification of
the machine, use genuine Toro replacement parts and
accessories. Replacement partsandaccessoriesmade
by other manufacturers may result in non-conformance
with the safety standards and the warranty may be
voided.
13.When changing attachments, tires or performing
other service, use correct blocks, hoists and jacks.
Make sure machine is parkedonasolidlevelsurface
such as a concrete floor. Prior to raising the machine,re-
move any attachments that may interfere with the safe
and proper raising of the machine. Always chock or
block wheels. Use appropriate jack stands to support
the raised machine. If the machine is not properly sup-
ported by jack stands, the machine may move or fall,
which may result in personal injury.