Toro 30873 Lawn Mower User Manual


 
Groundsmaster 4500--D/4700--D Hydraulic SystemPage 4 -- 141
Removal (Fig. 119)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. To prevent contamination of hydraulic system during
lift cylinder removal, thoroughly clean exterior of lift cyl-
inder.
WARNING
Make sure that cutting decks are fully lowered
before loosening hydraulic lines from lift cylin-
der. If decks are raised as hydraulic lines are
loosened, decks may drop unexpectedly.
4. Disconnect hydraulic hoses from lift cylinder. Put
caps or plugs on open hoses and fittings to prevent sys-
tem contamination. Label disconnected hydraulic hoses
for proper assembly.
5. Remove flange nut and flange head screw that se-
cure the cylinder pin (item 4) to the lift arm. Remove pin
from lift arm and cylinder shaft clevis which will free lift
cylinder from lift arm.
6. Remove flange nut and flange head screw that se-
cure the cylinder pin (item 12) to the frame. Pull pin from
frame and cylinder barrel clevis.
7. Remove lift cylinder from machine.
8. If hydraulic fittings are to be removed from lift cylin-
der, mark fitting orientation to allow correct assembly.
Remove fittings from cylinder and discard O--rings.
NOTE: For lift cylinder disassembly and assembly pro-
cedures, see Lift Cylinder Service in this section.
Installation (Fig. 119)
1. If fittings were removed from lift cylinder, lubricate
and place new O--rings onto fittings. Install fittings into
cylinder openings using marks made during the removal
process to properly orientate fittings. Tighten fittings
(see Hydraulic Fitting Installation in the General Infor-
mation section of this chapter).
2. Position cylinder barrel clevis to frame and insert cyl-
inder pin (item 12) into frame and clevis. Secure pin with
flange nut and flange head screw.
3. Insert cylinder pin (item 4) through lift arm and cylin-
der shaft clevis. Secure pin to lift arm with flange nut and
flange head screw.
4. Remove caps and p lugs from hydraulic hoses and
fittings. Attach hydraulic hoses to lift cylinder (see Hy-
draulic Hose and Tube Installation in the General Infor-
mation section of this chapter).
5. Fill reservoir with hydraulic fluid as required.
6. Lubricate lift cylinder grease fittings.
7. After assembly is completed, operate lift cylinder to
verify that lift cylinder, hydraulic hoses and fittings do not
contact any machine components during operation.
Figure 120
#4 Deck #1 Deck #5 Deck
#7 Deck
(GM4700)
#6 Deck
(GM4700)
#3
Deck
#2
Deck
CUTTING DECK LOCATIONS
Hydraulic
System