Filter
Top Products
Greensmaster 3320/3420Groomer Page 9 -- 26
Groomer Brush
Figure 32
1. Groomer brush shaft
2. Lock nut
3. J--bolt
4. Groomer brush
5. O--ring
20 to 25 in--lb
(2.3 to 2.8 N--m)
20 to 25 in--lb
(2.3 to 2.8 N--m)
3
1
2
4
2
3
5
The groomer brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
thegroomer brush uses the same procedure asremoval
and installation of the grooming reel (see Grooming
Reel in this section).
To removethe groomer brushfrom theshaft, remove the
lock nut a ndJ--bolt from both ends ofthe brushand slide
the brush from the shaft. When assembling the brush to
the shaft, secure the assembly with J--bolts and lock
nuts. Make sure that the J--bolts are installed with the
threaded portion on the outside of the brush (Fig. 33).
Torque lock nuts from 20 to 25 in--lb (2.3 to 2.8 N --m).
1. J--bolt 2. Lock nut
Figure 33
2
1