Filter
Top Products
Greensmaster 3320 Page 3 -- 9 Gasoline Engine
Removal (Fig. 3)
1. Parkmachineon alevelsurface, disengage and low-
er cutting units, move functional control lever to neutral
(N), engage parking brake, stop the engine and remove
the key from the ignition switch. Wait for all machine
movement to stop.
DANGER
Gasolineis flammable.Use cautionwhenstoring
or handling it. Do not smoke while filling the fuel
tank. Do not fill fuel tank while engine is running
or in an enclosed area. Always fill fuel tank out-
side and wipe up any spilled fuel before starting
the engine. Store fuel in a clean, safety--ap-
proved container and keep the cap in place. Use
gasoline for the engine only; not for any other
purpose.
2. Access the carbon cannister under the fuel tank and
between therear frame sections.If necessary,raise and
support tankmount plate assembly (hydraulicreservoir,
fuel tank and tank mount plate) to reach the cannister
(see Tank Mount Plate Assembly in the Service and Re-
pairs section of Chapter 7 -- Chassis).
3. Inspect carbon cannister for damage or obvious
leaks. A damaged or leaking cannister should be r e-
placed.
4. Remove components as needed using Figure 3 as
a guide.
A. Ifcheckvalve (item15)is removed,notedirection
of arrow on valve body for assembly purposes.
Installation (Fig. 3)
1. Install all removed components using Figure 3 as a
guide.
A. If check valve (item 15) was removed, make sure
that arrow on valve body points toward engine.
B. Make sure that fuel hoses are not kinked after
installation. Also,secure all hoses withhose clamps.
2. If tank mount plate assembly (hydraulic reservoir,
fuel tank and tank mount pla te) wasraised toaccess the
cannister, lower and secure tank mount plate assembly
(see Tank Mount Plate Assembly in the Service and Re-
pairs section of Chapter 7 -- Chassis).
Figure 4
1. Carbon cannister
2. Hose to tank vent
3. Hose to engine
3
2
1
FRONT
Gasoline
Engine