Filter
Top Products
Greensmaster 3320/3420 Page 7 -- 5 Chassis
Adjustments
Parking Brake Adjustment
1. Parkmachine on alevel surface,engage theparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. With parking brake engaged, measure the distance
between the centers of the two (2) pins that secure the
brake spring to the brake lever and the equalizer brack-
et. This distance should be from 6.120” to 6.240” (156
to 158 mm) (Fig. 4).
3. If necessary, adjust location of brake cable jam nuts
at brake cable bracket so that distance between pins is
correct.
4. After adjusting parking brake cables, check that
brake a ctuator levers are fully released when parking
brake is not applied. Also, when parking brake is notap-
plied, front wheels should rotate freely.
1. Brake lever (engaged)
2. Lever pin
3. Equalizer pin
4. Brake spring
Figure 4
2
1
3
4
6.120” to 6.240”
(156 to 158 mm)
1. Brake cable (RH shown)
2. Jam nuts
3. E--ring
4. Clevis pin
5. Brake assembly
Figure 5
1
2
4
3
5
Chassis