Filter
Top Products
Greensmaster 3320/3420 Page 7 -- 21 Chassis
Disassembly (Fig. 18)
1. Parkmachine on alevel surface,engage theparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Disconnect thecutting unitsfromtheelectrical power
supply by separating the cutting unit power disconnect
couplers (see Opening Electrical Circuit to Cutting Units
in the General Information section of this chapter).
3. Remove gr ass basket f rom suspension assembly.
4. Remove cutting unitfrom suspension assembly (see
Traction Unit Operator’s Manual).
5. Disassembly crossarm assembly as required using
Figure 18 as a guide.
NOTE: The flange head screws (item 13) used to se-
curethe baskethorn(item 12) tothecrossarm assembly
have a patch lock to prevent loosening of the screws. If
screws are removed, replace screws.
Assembly (Fig. 18)
1. Assemble crossarm assembly using Figure 18 as a
guide.
2. Install cutting unit to suspension assembly (see
Traction Unit Operator’s Manual).
3. Install grass basket.
4. Connect the cutting unit power disconnect couplers.
Chassis