Filter
Top Products
Groundsmaster 4500--D/4700--DPage 1 -- 2Safety
General Safety Instructions
The Groundsmaster 4500-D and 4700--D have been
tested and certified by TORO for compliance with exist-
ing safety standards and specifications. Although haz-
ard control and accident prevention partially are
dependentupon thedesign andconfiguration ofthema-
chine, these factors are also dependent upon the
awareness, concern and proper training of the person-
nel involved in the operation, transport, maintenance
and storage of the machine. Improper use or mainte-
nance ofthe machine canresult in injuryor death. Tore-
duce the potential for injury or death, comply with the
following safety instructions.
WARNING
To reduce the potential for injury or death,
comply with the following safety instructions.
Before Operating
1. Review and understand the contents of the Opera-
tor’s Manuals and Operator’s DVD before starting and
operating the vehicle. Become familiar with the controls
and know how to stop the vehicle and engine quickly.
Additionalcopiesofthe Operator’sManual areavailable
on the internet at www.Toro.com.
2. Keep all shields, safety devices and decals in place.
If ashield, safety deviceor decal is defective,illegible or
damaged, repair or replace it before operating the ma-
chine.Also tightenany loosenuts, boltsor screws to en-
sure machine is in safe operating condition.
3. Assure interlock switches are adjusted correctly so
engine cannot be started unless traction pedal is in
NEUTRAL and cutting decks are DISENGAGED.
4. Since diesel fuel is highly flammable, handle it care-
fully:
A. Use an approved fuel container.
B. Donot removefuel tankcapwhile engineishot or
running.
C. Do not smoke while handling fuel.
D. Fillfuel tankoutdoors andonly towithin aninch of
the top of the tank, not the filler neck. Do not overfill.
E. Wipe up any spilled fuel.
While Operating
1. Sit on the seat when starting and operating the ma-
chine.
2. Before starting the engine:
A. Engage the parking brake.
B. Make sure traction pedal is in neutral and the
PTO switch is OFF (disengaged).
C. Afterengine isstarted, releaseparking brakeand
keep foot off traction pedal.Machine must notmove.
If movement is evident, the traction pedal linkage is
adjusted incorrectly; therefore, shut engine off and
adjust traction pedal linkage until machine does not
move when traction pedal is released.
3. Do not run engine in a confined area without ade-
quate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
4. Donot touchengine,exhaustsystemcomponents or
radiator while engine is running or soon after it is
stopped. These areas could be hot enough to cause
burns.
5. Before getting off the seat:
A. Ensure that traction pedal is in neutral.
B. Engage parking brake.
C. Disengage PTO and wait for deck blades tostop.
D. Stop engine and remove key from switch.
E. Toro recommends that anytime the machine is
parked (short or long term),the cutting decks should
be lowered to the ground. This relieves pressure
from the lift circuit and eliminates the risk of cutting
decks accidentally lowering to the ground.
F. Donotparkon slopesunlesswheels arechocked
or blocked.