Filter
Top Products
Groundsmaster 4500--D/4700--DPage 6 -- 20Axles, Planetaries and Brakes
Installation
1. Coat new shaft seal with grease and install in axle
case as shown (Fig. 18).
1. Axle case
2. Bevel gear case
3. Shaft seal
Figure 18
1
2
3
2. Install the lower bevel gear and bevel gear shaft in
the axle case cover. Coat a new O-ring with grease and
install the axle case cover (Fig. 19). Tighten cover
screws from 17 to 20 ft-lb (23 to 27 N--m).
3. Slide the bevel gear case over the bevel gear shaft
andinstallthebevelgearandcollar.Makesurethebevel
gear shaft is completely seated in the upper and lower
bearings (Fig. 19).
4. Installtheknuckle pin.Usemedium strengththread--
locking compoundand tightenthe knuckle pinmounting
screws from 17 to 20 ft-lb (23 to 27 N--m).
1. Axle case cover
2. Lower bevel gear
3. Bevel gear shaft
4. Lower bearing
5. Upper bevel gear
6. Collar
7. Upper bearing
8. Knuckle pin
Figure 19
1
2
3
4
5
6
7
8