Filter
Top Products
Groundsmaster 4500--D/4700--D Page 3 -- 15 Kubota Diesel Engine
7. Position upper radiator shroud to the radiator. Secu-
re shroud to the radiator and lower radiator bracket with
removedfasteners (seeRadiator Installationin thissec-
tion). Make sure that clearancebetween shroudand fan
is at least 0.180” (4.6 mm) at all points.
8. Connectthrottle cable to thespeed control lever with
washer and lock nut. Install cable to mounting bracket.
Adjust throttle cable.
9. Connect throttle cable to engine (Fig. 11):
A. Secure throttle cable swivel to speed control le-
ver with lock nut.
B. Place throttle cable under cable clamp.
C. Adjust throttle cable position in cable clamp so
that engine governor lever contacts the high speed
stop bolt at the same time that the throttle lever con-
tacts the end of the slot in the control console.
D. Tighten cable clamp to secure throttle cable.
10.Remove caps from fuel hose and injector pump fuel
inlet that were placed during engine removal to prevent
contamination. Connect fuel supply hose to injection
pump (Fig. 11).
11.Connect wire harness connectors to the following
engine components:
A. The engine run solenoid (Fig. 11).
B. The temperature sender (Fig. 12).
C. The alternator (Fig. 12).
D. The glow plug connection.
E. Wire harness connector to engine ground har-
ness.
F. Theelectricstarter.TorquenutatstarterB+termi-
nal from 70 to 86 in--lb (7.9 to 9.7 N--m).
G. Low oilpressureswitch locatedon alternatorside
of engine (above electric starter).
12.Using notes taken during engine removal, secure
wires with cable ties in proper locations.
13.Install air cleaner assembly to the engine (see Air
Cleaner Installation in this section).
14.Install exhaust system to machine (see Muffler
Installation in this section).
15.Connect coolanthoses tothe radiator. Make sure ra-
diatordraincockis closed.Fillradiator andreservoirwith
coolant.
16.Check position of wires, fuel lines, hydraulic hoses
and cables for proper clearance with rotating, high tem-
perature and moving components.
17.Connect positive battery cable first and then nega-
tive battery cable. Secure battery cover to machine.
18.Check and adjust engine oil level as needed.
19.Check and adjust hydraulic oil level as needed.
20.Bleed fuel system.
21.Operate hydraulic controls to properly fill hydraulic
system (see Charge Hydraulic System in the Service
and Repairs sectionof Chapter 4 -- H ydraulic Systems).
22.Install hood onthe machine (seeHood Installation in
the Service and Repairs section of Chapter 7 -- Chas-
sis).
Kubota
Diesel Engine