Filter
Top Products
Groundsmaster 3505--DHydraulic System Page 4 -- 56
Oil Cooler
Removal
1. Thoroughly clean hydraulichose ends and fittingson
oil cooler to prevent hydraulic system contamination.
CAUTION
The radiator and oil cooler may be hot. To avoid
possible burns, allow the engine and cooling
systems to cool before working on the oil cooler.
2. Remove oil cooler using Figures 34 and 35 as
guides.
Inspection
CAUTION
Use eye protection such as goggles when using
compressed air.
1. Backflush oil coolerwith cleaningsolvent. After cool-
er is clean, make sure all solvent is drained from the
cooler.
2. Dry inside of oil cooler using compressed air in the
opposite direction of the oil flow.
3. Plug both ends of oil cooler. Clean exterior of cooler.
Make sure oil cooler fins are clear of dirt and debris.
4. The oil cooler should be free of corrosion, cracked
tubes or excessive pitting of tubes.
Installation
1. Install oil cooler using Figures 34 and 35 as guides.
2. Make surehydraulic tank is full. Add correct oilif nec-
essary (see Traction Unit Operator’s Manual).
1. Oil cooler 2. Latch
Figure 34
1
2
1. Oil cooler
2. Barb fitting (2 used)
3. Hydraulic hose (2 used)
4. Hose clamp (4 used)
5. Flow to oil filter
6. Flow from manifold
Figure 35
FRONT
RIGHT
1
3
4
2
5
6