Filter
Top Products
Groundsmaster 3505--D Page 3 -- 9 Kubota Diesel Engine
DANGER
Because dieselfuel ishighly flammable, usecau-
tion when storing or handling it. Do not smoke
while filling the fuel tank. Do not fill fuel tank
while engine is running or hot or when machine
is in an enclosed area. Always fill fuel tank out-
side and clean up any spilled diesel fuel before
starting the engine. Store fuel in a clean, safety--
approved container and keep cap in place. Use
diesel fuel for the engine only; not for any other
purpose.
Check Fuel Lines and Connections
Check fuel lines and connections every 400 hours or
yearly, whichever comes first.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch. Unlatch and raise hood.
2. Check fuel lines for deterioration, damage, leaks or
loose connections.Replace hoses,clamps andconnec-
tions as necessary.
Fuel Tank Removal (Fig. 4)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch. Unlatch and raise hood.
2. Remove fuel from the tank into a suitable container.
Crossover fuel hose (item 44) removal may assist to
drain tank completely.
3. Remove seatand seat support straps from theframe
(see Operator Seat Removal in Chapter 6 -- Chassis).
Note location of spacers under front of seat support
straps. Disconnect seat switch from the electrical har-
ness (Fig. 5).
4. Remove fuel hosestrap and both fuel hoses fromthe
fuel tank. Pull tank from the machine (Fig. 5).
Drain and Clean Fuel Tank
Drain and clean the fuel tank every 2 years. Also, drain
and clean the fuel tank if the fuel system becomes con-
taminated or if the machine is to be stored for an ex-
tended period.
1. Remove fuel tank from the machine (see Fuel Tank
Removal).
2. Flush fuel tank out with clean diesel fuel. Make sure
that tank is free of all contaminates and debris.
3. Install fuel tank to the machine (see Fuel Tank Instal-
lation).
Fuel Tank Installation (Fig. 4 )
1. Position fuel tank to the machine.
2. Connect both fuel hoses to the tank and secure with
hose clamps and fuel hose strap.
3. Connect seat switch to the electrical harness. Route
seat switch wire under seat support strap. Secure seat
support straps and seat to the frame (see Operator Seat
Installation in Chapter 6 -- Chassis).
4. Check for correct seat operation and also that seat
switch wires and connector are not pinched and do not
contact any moving parts.
5. Fill fuel tank (see Traction Unit Operator’s Manual).
Figure 5
1. Seat support strap
2. Hex flange head screw
3. Electrical harness
4. Fuel hose strap
5. Fuel hose
1
3
4
5
2
Kubota
Diesel Engine