Filter
Top Products
Groundsmaster 3505--D Page 3 -- 15 Kubota Diesel Engine
6. Secure wire harness to the front lift tab and the en-
gine with cable ties.
7. Install all hydraulic hoses to the piston and gear
pumps. Install traction control cable to the neutral arm
assembly onthe pistonpump (seePiston Pump Installa-
tion in Chapter 4-- Hydraulic System).
8. Connect fuelhose to the fuel/water separator (Fig.8)
and front injector nozzle.
9. Install top fan shroud to the radiator. Install expan-
sion tankand bracketto thetop fanshroud (seeRadiator
Installation in this section).
10.Connect electrical wires to engine:
A. Negative battery cable and wire harness ground
(Fig. 8).
B. Glow plug bus (Fig. 9) and fuel stop solenoid.
C. High temperature warning switch (Fig. 10).
D. High temperature s hutdown switch, alternator
and oil pressure switch (Fig. 11).
11.Securewire harness to enginewith cableties at loca-
tions noted during engine removal.
12.Connect coolant hoses to the water pump and en-
gine block. Close radiator drain cock valve. Fill radiator
with coolant (see Traction Unit Operator’s Manual).
13.Install muffler to the exhaust manifold and muffler
bracket (see Muffler Installation in this section).
14.Connect throttle cable to the support bracket and
swivel on the speed control lever (Fig. 8).
15.Connect both battery cables to the battery (see Bat-
tery Service in Chapter 5 -- Electrical system).
16.Install air cleaner to the engine (see Air Cleaner As-
sembly Installation in this section). Connect air hose to
air cleaner and radiator.
17.Adjust throttle cable (see Adjust Throttle Cable).
18.Bleed fuel system (see Traction Unit Operator ’s
Manual).
19.Install hood tothe machine (seeTractionUnit Opera-
tor’s Manual). Close and latch hood.
20.Check hydraulic oil level (see Traction Unit Opera-
tor’s Manual). Adjust as needed.
21.Check traction drive for neutral (see Traction Unit
Operator’s Manual). Adjust as needed.