Filter
Top Products
Groundsmaster 3505--D Hydraulic SystemPage 4 -- 99
Removal (Fig. 65)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Thoroughly clean hydraulichose ends and fittingson
lift cylinder to prevent hydraulic system contamination.
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor -
mation section.
3. Remove rear lift cylinder from the frame and lift arm
using Figure 65 as guide.
4. If hydraulic fittings are to be removed from lift cylin-
der, mark fitting orientation to allow correct assembly.
Installation (Fig. 65)
1. If fittings were removed, install fittings to lift cylinder
using marks made during the removal process to prop-
erly orientate fittings.
2. Install rear lift cylinder to the frame and lift arm using
Figure 65 as guide.
3. Make surehydraulic tank is full. Add correct oilif nec-
essary (see Traction Unit Operator’s Manual).
4. Adjust rear lift arm (see Traction Unit Operator’s
Manual).
Hydraulic
System