Filter
Top Products
Groundsmaster 4100--D/4110--DCutting Deck
Page 8 -- 16
Blade Spindle
1. Cutting deck
2. Drive s pindle: single pulley (2 used)
3. Low driven spindle (3 used)
4. Drive spindle: double pulley (1 used)
5. High driven spindle (1 used)
6. Flange nut
7. Blade bolt
8. Cutting blade (7 used)
9. Anti--scalp cup
10. Flat washer
11. Cap screw
Figure 13
4
3
1
11
88 to 108 ft--lb
(119 to 146 N--m)
2
FRONT
RIGHT
5
7
6
9
8
10
Removal (Fig. 13)
1. Parkmachineonalevelsurface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. If drive spindle is to be serviced, remove hydraulic
motor from cutting deck (see Cutting Deck Motor Re-
moval in the Service and Repairs Section of Chapter 4
-- Hydraulic System). Position motor away from spindle.
3. Remove belt covers from top of cutting deck. Loosen
idler pulley to release belt tension (see Idler Assembly
Removal in this section). Remove drive belt from spindle
to be serviced.
4. Start the engine and raise the cutting deck. Stop en-
gine and remove key from the ignition switch. Latch or
block up the cutting deck so it cannot fall accidentally.
5. Remove cutting blade, anti--scalp cup and blade bolt
from spindle to be serviced.
6. Remove spindle housing assembly from deck:
A. For driven spindle assemblies, remove eight (8)
flange nuts that secure spindle to deck.
B. For drive spindle assemblies, loosen and remove
four (4) flange nuts that secure spindle to deck.
Then, remove four (4) cap scr ews with flat washers
that secure spindle and motor mount to deck.
7. If necessary, press screws from spindle housing.