Filter
Top Products
Groundsmaster 4100--D/4110--DCutting Deck
Page 8 -- 8
NOTE: Installation of clevis pins to deck and height--of--
cut chains is easier if deck is lifted slightly.
4. Install clevis pins and hairpins that secure the
height --of--cut chains to the rear of the cutting deck (Fig.
2).
5. Remove plugs from hydraulic hoses and fittings on
wing deck lift cylinders. Using labels placed during re-
moval, correctly attach hydraulic hoses to lift cylinders.
6. Connect cutting deck wire harness to machine wire
harness.
7. Position damper to cutting deck bracket. Place
spacer between cutting deck bracket and damper clevis
end. Secure damper to bracket with spring pin (Fig. 5).
8. Install all removed cutting deck covers.
9. Install hydraulic motors to cutting deck (see Cutting
Deck Motors in the Service and Repairs Section of
Chapter 4 -- Hydraulic System).
10.Lubricate grease fittings on cutting deck and lift as-
semblies.
11.Check and fill hydraulic reservoir w ith hydraulic fluid
as required.
1. Lift arm
2. Castor arm
3. Support hub
4. Damper assembly
Figure 5
1
2
3
4