Filter
Top Products
Groundsmaster 4100--D/4110--DHydraulic System Page 4 -- 124
Cutting Deck Motor Service (Casappa)
(45 to 55 N--m)
33 to 40 ft--lb
8
7
4
3
2
6
9
10
11
9
12
13
8
14
16
15
14
1
1. Flange washer
2. O--ring
3. Front flange
4. Dust seal
5. Retaining ring
6. Front wear plate
7. Shaft seal
8. Backup gasket
9. Pressure seal
10. Rear wear plate
11. Body
12. Idler gear
13. Cap screw (4 used)
14. Dowel (4 used)
15. Drive gear
16. Washer (4 used)
17. Rear cover
Figure 96
5
2
17
The Casappa cutting deck motors have similar con-
struction as the cooling fan motor (also a Casappa
brand) used on the Groundsmaster 4100--D and
4110--D. The deck motors have a separate rear cover
(item 17 in Fig. 96) which is a difference from the cooling
fan motor which includes the rear cover with the motor
body. Orientation of the dust seal (item 4 in Fig. 96) is dif-
ferent in the deck motors than in the cooling fan motor.
For disassembly, inspection and assembly procedures
of the Casappa cutting deck motors, refer to Engine
Cooling Fan Motor Service in this section. When in-
stalling the seals into the front flange in a cutting deck
motor, use the orientation shown in Figure 97.
NOTE: Internal components for a cut ting deck motor
are not available separately. Disassemble motor for
cleaning, inspection and seal replacement only.
Figure 97
1
2
3
4
1. Dust seal
2. Retaining ring
3. Flange washer
4. Shaft seal