Filter
Top Products
17
Chapter 2: Preparing for Use
3 Inspect the product for physical damage.
Check the logic analyzer and the supplied accessories for obvious physical or
mechanical defects. If you find any defects, contact your nearest Agilent
Technologies Sales Office. Arrangements for repair or replacement are made, at
Agilent Technologies' option, without waiting for a claim settlement.
To apply power
These steps are required for all 1680A,AD and 1690A,AD-series logic analyzers.
1 Connect the power cord to the instrument and to the power source.
This instrument autodetects the line voltage from 115 VAC to 230 VAC. It is
equipped with a three-wire power cable. When connected to an appropriate AC
power outlet, this cable grounds the instrument cabinet. The type of power cable
plug shipped with the instrument depends on the country of destination. Refer to
chapter 7, "Replaceable Parts," for option numbers of available power cables.
2 Turn on the power switch located on the front panel.
To connect the 1690A,AD-series logic analyzer to a host PC
These steps are required for the Agilent 1690A,AD-series hosted logic analyzer.
The logic analyzer user interface requires a host computer (PC) with the
following characteristics (or better):
Intel Celeron, AMD K6-II 500 MHz
Windows 2000 Professional or Windows XP Professional
128MB RAM
IEEE 1394 PCI card
1 Connect one end of the 6-pin IEEE 1394 cable to the IEEE 1394 port on
the host PC.
2 Connect the free end of the IEEE 1394 cable to the IEEE 1394 port on the
logic analyzer.
3 Apply power to the PC if it is not turned on.