Filter
Top Products
135
Chapter 6: Replacing Assemblies
1690A,AD-series disassembly/assembly
4 Remove the fascia away from the front panel.
If the fascia requires replacement, a product ID label must also be ordered and
applied (refer to chapter 7 for the part number). Also, Pod labels (01680-94313)
must be ordered and applied in the same way as on the fascia being replaced.
Steps to remove the on/off switch from the fascia assembly
1 Using a Torx T-10 screwdriver, remove two screws that secure the on-off
switch circuit board to the fascia.
2 Lift the on/off switch circuit board out of the fascia.
3 Lift the on/off switch out of the fascia.
Reverse this procedure to assemble the fascia.