Filter
Top Products
56 Setting options and defaults
Setting Norton Ghost options and defaults
To install LPT peer-to-peer drivers
1 To set the default installation of LPT drivers, in the Ghost Basic window, click
Options.
2 In the Norton Ghost 2003 Options dialog box, click LPT Driver Settings.
3 Select a mode.
The default mode for an LPT connection is ECP/EPP High Speed. If you are
having problems with your LPT connection, set the mode to Bidirectional
8bit or Bidirectional 4bit. The next time that you create a boot disk, the mode
is reset to the default, ECP/EPP High Speed.
4 Select a port.
If you have multiple parallel ports and want to connect using a port other
than the default LPT1, use the LPT port option to specify the port into which
your cable is plugged.
5 Click OK.
Installing extra drivers
You can install drivers that are not included with Norton Ghost. You can also
modify Autoexec.bat and Config.sys, which are installed in the Virtual Partition.
To install extra drivers
1 Do one of the following:
■ To set the default installation of extra drivers, in the Ghost Basic
window, click Options.
■ To install the extra drivers while running a Windows wizard task, in the
Advanced Settings window, click Advanced Settings.
2 On the User files tab, click Add Files to add additional drivers.
3 Click Add Directory to add additional directories.
4 In the AUTOEXEC.BAT Additions field, type any additional Autoexec.bat
entries for the driver.
5 In the CONFIG.SYS Additions field, type any additional Config.sys entries
for the driver.
6 Click OK.