Filter
Top Products
47Setting options and defaults
Setting Norton Ghost options and defaults
Adding command-line switches to a task
You can add command-line switches to a task to alter its operation.
To add command-line switches to a task
1 Do one of the following:
■ To set this option as a default, in the Ghost Basic window, click Options.
■ To add command-line switches while running a Windows wizard task,
in the settings window, click Advanced Settings.
2 On the Ghost Command Line tab, type the extra command-line switches.
See “Using Norton Ghost with switches” on page 154.
3 Click OK.
Warning: The syntax of your command line is not checked when the task
runs. Therefore, review these instructions carefully to avoid errors. The
consequences of an error could be serious.
Assigning a drive letter to a CD/DVD drive
You can assign a drive letter to a CD or DVD drive. This lets you select a drive
letter when restoring an image file from a CD/DVD.
Use this option if you are restoring an image file that was written to a CD/DVD
using a tool other than Norton Ghost.
To assign a drive letter to a CD/DVD drive
1 Do one of the following:
■ To set this option as a default, in the Ghost Basic window, click Options.
■ To assign a drive letter to a CD or DVD drive while running a Windows
wizard task, in the Advanced Settings window, click Advanced Settings.
2 On the CD Driver tab, click Assign drive letters to CD/DVD drives.
3 Click OK.
Setting the options for a mapped network drive
You can set the options for connecting to a mapped network drive.