Filter
Top Products
53Setting options and defaults
Setting Norton Ghost options and defaults
To specify additional free space in the Virtual Partition
1 Do one of the following:
■ To set the default to specify additional free space, in the Ghost Basic
window, click Options.
■ To specify additional free space while running a Windows wizard task,
in the Advanced Settings window, click Advanced Settings.
2 In the Norton Ghost 2003 Options window, on the Virtual Partition Free
Space tab, in the Required Free Space field, select an additional amount of
free space (in MB) to add to the Virtual Partition.
3 Click OK.
Installing SCSI drivers
Norton Ghost automatically installs Adaptec SCSI drivers in the Virtual Partition
if it finds a SCSI hard disk. The SCSI drivers allow Norton Ghost to access any
SCSI device. If you want to install SCSI drivers manually, you can set this as a
default preference or install the drivers from a wizard. You can scan for Adaptec
SCSI cards and let Norton Ghost select the correct drives.
If you are using a card other than Adaptec, then you must manually install the
correct drivers.
See “Installing extra drivers” on page 56.
To install SCSI drivers
1 Do one of the following:
■ To set the default installation of SCSI drivers, in the Ghost Basic
window, click Options.
■ To install the SCSI drivers while running a task, in the Advanced
Settings window, click Advanced Settings.
2 Check the SCSI drivers that you want to install.
3 To let Norton Ghost scan for Adaptec SCSI cards, click Auto-Detect for SCSI
drivers.
4 Click OK.