OF THE USE OR INABILITY TO USE THE SOFTWARE EVEN IF
SYMANTEC HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.
IN NO CASE SHALL SYMANTEC'S OR ITS LICENSORS' LIABILITY
EXCEED THE PURCHASE PRICE FOR THE SOFTWARE. The
disclaimers and limitations set forth above will apply regardless of
whether You accept the Software.
6. U.S. GOVERNMENT RESTRICTED RIGHTS:
RESTRICTED RIGHTS LEGEND. All Symantec products and
documentation are commercial in nature. The software and software
documentation are "Commercial Items", as that term is defined in 48
C.F.R. section 2.101, consisting of "Commercial Computer Software"
and "Commercial Computer Software Documentation", as such terms
are defined in 48 C.F.R. section 252.227-7014(a)(5) and 48 C.F.R.
section 252.227-7014(a)(1), and used in 48 C.F.R. section 12.212 and
48 C.F.R. section 227.7202, as applicable. Consistent with 48 C.F.R.
section 12.212, 48 C.F.R. section 252.227-7015, 48 C.F.R. section
227.7202 through 227.7202-4, 48 C.F.R. section 52.227-14, and other
relevant sections of the Code of Federal Regulations, as applicable,
Symantec's computer software and computer software documentation
are licensed to United States Government end users with only those
rights as granted to all other end users, according to the terms and
conditions contained in this license agreement. Manufacturer is
Symantec Corporation, 20330 Stevens Creek Blvd., Cupertino, CA
95014.
7. EXPORT REGULATION:
Export, re-export of this Software is governed by the laws and
regulations of the United States and import laws and regulations of
certain other countries. Export or re-export of Software to any entity
on the Denied Parties List and other lists promulgated by various
agencies of the United States Federal Government is strictly prohibited.
8. GENERAL:
If You are located in North America or Latin America, this Agreement
will be governed by the laws of the State of California, United States of
America. Otherwise, this Agreement will be governed by the laws of
England. This Agreement and any related License Module is the entire
agreement between You and Symantec relating to the Software and: (i)
supersedes all prior or contemporaneous oral or written
communications, proposals and representations with respect to its
subject matter; and (ii) prevails over any conflicting or additional
terms of any quote, order, acknowledgment or similar
communications between the parties. This Agreement may only be
modified by a License Module or by a written document which has
been signed by both You and Symantec. This Agreement shall
terminate upon Your breach of any term contained herein and You
shall cease use of and destroy all copies of the Software. The
disclaimers of warranties and damages and limitations on liability shall
survive termination. Should You have any questions concerning this
Agreement, or if You desire to contact Symantec for any reason, please
write: (i) Symantec Customer Service, 555 International Way,
Springfield, OR 97477, USA, or (ii) Symantec Customer Service
Center, PO BOX 5689, Dublin 15, Ireland.
9. ADDITIONAL USES AND RESTRICTIONS:
Notwithstanding any of the terms and conditions contained in the
Symantec Corporation Software License Agreement, the following
additional terms apply to the product you have purchased. You may:
(i) use the Software on one computer to clone, or apply an image of, a
hard drive on that computer, or a portion thereof, to another hard
drive on the same computer, a replacement computer, secondary
media, or network drive. If a License Module accompanies, precedes,
or follows this license, you may make and use that number of copies of
the Software licensed to you by Symantec as provided in your License
Module on an equal number of individual computers pursuant to the
terms of this license. Your License Module shall constitute proof of
your right to make and use such copies;
(ii) use the Software on that same computer to create an image file of a
hard drive on that computer and store the image file on removable
media for disaster recovery purposes;
(iii) use the Software to create a boot disk as described in the
documentation for reapplying the hard drive image that was created
for disaster recovery purposes to the hard drive on that same
computer; and
(iv) use the Software to clone a hard drive from that same computer to
a replacement computer, in the manner described in the software
documentation, and to use the Software on the replacement computer
provided that the Software has been removed from the original
computer.
You may not use the Software commercially or non-commercially for
the purpose of creating multiple computers or hard drives not
connected to the original computer, with similar or identical
configurations to that of the original computer or hard drive.