Filter
Top Products
Appendix B Configuration Utility Error Messages 175
Sun Proprietary/Confidential: Internal Use Only
Other Error Messages
TABLE B-4 Other SUNWsecfg Error Messages
Source of Error Message Cause of Error Message Suggested Corrective Action
Common to all
components
If the Sun StorEdge 3900 or 6900
series has more than two failures
(for example, both virtualization
engines and two switches are
down), the getcabinettool might
not determine the correct cabinet
type. In this example, the
getcabinet command might
determine the device to be a Sun
StorEdge 3900 series when, in
reality, it is a Sun StorEdge 6900
series.
Set the BOXTYPE variable as
follows:
BOXTYPE=6910; export BOXTYPE
checkdefaultconfig • Could not determine the Sun
StorEdge system type.
• Multiple components might be
down and the getcabinet
command could not determine the
Sun StorEdge series type (3910,
3960, 6910, or 6960).
To use the command line interface
(CLI), set the BOXTYPE
environment variable to one of the
seven values.
For example, BOXTYPE=3910;
export BOXTYPE.
listavailable • The component is unavailable. It
is either not found or the
configuration lock is set.
• The components are down (they
do not respond to a ping).
• Another SUNWsecfg command
is running and is updating the
configuration (ps -ef).
If no other commands are running
and you believe the configuration
lock might be set in error, run the
removelocks command.
setdefaultconfig The systemcould not determine the
Sun StorEdge system type.
To use the command line interface
(CLI), set the BOXTYPE
environment variable to one of the
four values.
For example, BOXTYPE=3910;
export BOXTYPE.