Filter
Top Products
140 Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003
Sun Proprietary/Confidential: Internal Use Only
▼
To Use the Sun StorEdge T3+ Array Failover Driver GUI
Note – The Sun StorEdge T3+ Array Failover Driver GUI is limited to the Sun
StorEdge 3900 series systems. You must use the CLI for the Sun StorEdge 6900 series
systems.
1. Make sure the Sun StorEdge T3+ Array failover driver is loaded.
From the Microsoft Windows 2000 Advanced Server GUI, click Administrative
Tools -> Computer Management -> Software Environment.
2. Ensure the "Jafo" driver is in a Running and OK state.
3. Launch the Sun StorEdge T3+ Array Failover Driver GUI using instructions found
in “Launching the Sun StorEdge T3+ Array Failover Driver GUI” on page 138.
The Multipath Configurator window is displayed.
A healthy Sun StorEdge 3900 series system has a solid line connecting the HBA to
the storage, as shown in
FIGURE 10-3.
FIGURE 10-3 Healthy Sun StorEdge 3900 series system, shown using Multipath
Configurator
Note – Note the connection between the two arrays, indicating that the back end
loop is being used.