Sun Microsystems 3900 Outdoor Storage User Manual


 
Appendix B Configuration Utility Error Messages 169
Sun Proprietary/Confidential: Internal Use Only
checkswitch The current configuration on
$switch does not match the defined
configuration.
One of the predefined static switch
configuration parameters that can be
overridden for special configurations
(such as NT connect or cascaded
switches) is set incorrectly.
1. Select View Logs or see $LOGFILE
for more details.
2. Rerun setupswitch on the
specified $switch.
checkswitch The other back-end switch is not the
same type as this switch. Firmware
should be upgraded or downgraded
so the two switches match.
Run the following command on the
other back-end switch to upgrade it:
setswitchflash -s switch2 -f
/usr/opt/SUNWsmgr2/firmware/S
ANbox1/16040233.fls
checkswitch
(2 Gbit switches)
modifyswitch
(2 Gbit switches)
saveswitch
(2 Gbit switches)
No active zone set found.
2 Gbit switches have a zone
configuration with a zoneset and
zone(s). Each zone then has port or
WWN members. 1 Gbit switches had
numbered hard zones only.
1. Attempt to activate an existing
zone set.
2. /opt/SUNWsecfg/flib/sanbox2
-x switchip
get_zoneset_list
3. From that list, select the zoneset
you want to be active. It should be
named something similar to
hostname_sw1a_zset
4. /opt/SUNWsecfg/flib/sanbox2
-x switchip
activate_zoneset zoneset
5. If you are still having problems,
rerun setupswitch.
6. Rerun the initial command you
attempted to run.
restoreswitch Map file format or version is invalid
for switch type found. User must
have upgraded or changed out the
switch with a different type and did
not use the SUNWsecfg commands to
reconfigure.
1. cp
/opt/SUNWsecfg/etc/
”switch”.map
/opt/SUNWsecfg/etc/
”switch”.save
2. Run saveswitch -s switch
3. Manually edit the configurable
items in the
/opt/SUNWsecfg/etc/
”switch”.map file to valid values
that equal the values in
“switch”.save file.
4. Rerun restoreswitch -s
switch.
TABLE B-2 Sun StorEdge Network FC Switch Error Messages (Continued)
Source of Error Message Cause of Error Message Suggested Corrective Action