Filter
Top Products
174 Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003
Sun Proprietary/Confidential: Internal Use Only
restoret3config • $LUN configuration failed to
restore.
• The force option tried
unsuccessfully to reinitialize.
1. Check the Sun StorEdge T3+
configuration with the showt3
-n t3_name command.
2. Refer to the Sun StorEdge T3 and
T3+ documentation.
restoret3config • $LUN configuration is not found in
the $restore_file.
• Cannot restore $LUN.
1. Check for snapshot files in the
/opt/SUNWsecfg/etc/t3_name/
directory.
2. If the snapshot files are not found,
use the modifyt3config
command to configure the Sun
StorEdge T3+ array.
rmt3group An error occurred while removing
Group.
Refer to the Sun StorEdge T3 andT3+
array documentation.
rmt3slice An error failed to remove slice
$slicename.
Refer to the Sun StorEdge T3 andT3+
array documentation.
rmt3slice An error failed to remove slice from
volume $volume.
1. Check the volume status using the
checkt3mount or showt3
command.
2. If unmounted, use the
restoret3config command to
mount.
savet3config While checking the configuration, the
Sun StorEdge T3+ array
configuration was not saved.
1. If the configuration is different
from standard Sun StorEdge T3+
array configuration, run the
showt3 -n t3_namecommand.to
check the Sun StorEdge T3+ array
configuration.
2. Use the modifyt3config
command to reconfigure the
device.
sett3lunperm LUN $lun does not exist on the Sun
StorEdge T3+ array.
1. Create a Sun StorEdge T3+ array
slice.
2. Before setting permissions,use the
createt3slice command.
TABLE B-3 Sun StorEdge T3+ Array Error Messages (Continued)
Source of Error Message Cause of Error Message Suggested Corrective Action