Toro 30607 and 30609 Lawn Mower User Manual


 
Groundsmaster 4000--D/4010--DCutting Decks
Page 8 -- 14
Blade Spindle Service
1. Lock nut
2. Hardened washer
3. Driven pulley (single shown)
4. Spindle shaft
5. Drive pulley
6. Hydraulic motor mount
7. O--ring
8. Oil seal
9. Bearing cup and cone
10. Spacer set
11. Spindle housing
12. Grease fitting
13. Spindle shaft spacer
Figure 13
1
2
13
1
5
6
8
9
4
8
2
3
7
9
130 to 150 ft--lb
(176 to 203 N--m)
DRIVE SPINDLE
11
12
10
130 to 150 ft--lb
(176 to 203 N--m)
Disassembly (Fig. 13)
1. Loosen and remove lock nut from top of spindle
shaft. Remove hardened washer and pulley from
spindle. For drive spindle, remove hydraulic motor
mount.
2. Remove the spindle shaft from the spindle housing
whichmay requirethe useof an arborpress. Thespindle
shaft spacer should r emain on the spindle shaft as the
shaft is being removed.
3. Carefully remove oil seals from spindle housing tak-
ingcaretonotdamagesealboreinhousing.
4. Allow the bearing cones, inner bearing spacer and
spacer ring to drop out of the spindle housing (Fig. 14).
5. Using an arbor press, remove both of the bearing
cups and the outer bearing spacer from the housing.
6. The large snap ring can remain inside the spindle
housing. Removal of this snap ring is very difficult.
Assembly (Fig. 13)
NOTE: A replacementspindle bearing set contains two
(2) bearings, a spacer ring and a large snap ring (items
1, 2 and 3 in Fig. 14). These parts cannot be purchased
separately. Also, do not mix bearing set components
from one deck spindle to another.
NOTE: A replacement bearing spacer set includes the
inner spacer and outer spacer (items 4 and 5 in Fig. 14).
Do not mix bearing spacers from one deck spindle to
another.
IMPORTANT: If new bearings are installed into a
used spindle housing,it maynot benecessary tore-
place the original large snap ring. If the original
snap ring is in good condition with no evidence of
damage (e.g. spun bearing), leave the snap ring in
the housing and discard the snap ring that comes
with thenew bearings. If thelarge snapring isfound
to be damaged, replace the snap ring.
1. Iflargesnapringwasremovedfromspindlehousing,
install snap ring into housing groove. Make sure snap
ring is fully seated in housing groove.