Filter
Top Products
Groundsmaster 4000--D/4010--DPage 5 -- 10Electrical System
Main Menu Screen
The main menu screen can be accessed from the Info-
Center main information by p ressing and releasing the
menu/back button (left button) on the display. Once to
the mainmenuscreen(Fig. 12),navigationto the five(5)
different menu items can occur. Pressing the move t o
menu item button (center button) allows a different
menu item to be highlighted. Selectionof thehighlighted
item is completed by pressing the choose item button
(right bu tton).
The main menu items include faults, service, diagnos-
tics, settings and about. These menu items are de-
scribed below.
To return to the main information screen from the main
menu screen, press the back button (left button).
1. Main menu
2. Menu items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 12
1
3
4
5
3
4
Main Menu
Faults
Service
Diagnostics
2
5
Faults Screen
The faults screen (Fig. 13) will list all machine electrical
faults that have occurred since the faults were last
cleared from the InfoCenter. The faults will be identified
by a fault number and when the fault occurred. Faults
that might occur on the machine are listed in Fault
Codes in the Troubleshooting section of this chapter.
After entry of the PIN code, the InfoCenter fault log can
be cleared by selecting the clear system faults menu
item. The cleared faults will be removed from the Info-
Center list but will be retained in the TEC controller
memory.
If a f ault occurs during machine use, there m ay be a
change in machine functionality due to the fault. Should
there be machine operation issues due to a fault, a first
step to remedy the issue would be to disengage the cut-
ting decks, release the traction pedal, turn the ignition
switch OFF and allow all machine functions to stop.
Then, attempt to restart t he machine to see if operation
has returned to normal. Some faults will be reset during
the restart and will then allow normal function. If a fault
continues to occur, further system evaluation and pos-
sible component repair or replacement will be neces-
sary.
To return to the main menu screen from the faults
screen, press the back button (left button).
1. Fault menu
2. Fault items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 13
1
3
5
3
4
Faults
#39
Clear System Faults
-- 57.3 A go
2
5