Filter
Top Products
Removal and Installation Procedures
MTG100 & MTG300 MPEG Generator Service Manual
6Ć21
1. Assemble equipment and locate modules to be removed:
a. You need a screwdriver with a size #2 Phillips tips (Items 1 and 3).
b. Locate the module to be removed in the locator diagram External
modules, Figure 6-2, page 6-13.
2. Orient instrument: Set the MPEG generator so its right side is down on the
work surface and its front is facing you.
3. Remove front-panel unit: See Figure 6-8.
a. Using a screwdriver with a size #2 Phillips tip, remove the six screws
securing the front-panel unit to the chassis.
b. Set the MPEG generator so its bottom is down on the work surface and
its front is facing you.
c. Grasp the front-panel unit and pull it forward.
d. Unplug the cable at J250 of the A30 Front Panel board.
4. Reinstallation: Perform step 3 in reverse order to reinstall the front-panel
unit.
FrontĆPanel Unit